EUR 
Dollar
UK pound
Siemens 5WG1512-4CB23, JB512C23
KNX Switching actuator 1 x AC 120...277 V, 20 A or 1 x AC 347 V, 15 AX, C load
- One relay contact as switching element
- Bus-powered electronics
- Integrated bus coupling unit, Bus connection via bus terminal block
- Type of protection: IP 20
- Rated contact operating voltage AC 120...277 V, AC 347 V
- Rated contact frequency: 50/60 Hz
- Fluorsecent lamp load acc. to DIN EN 60669-1: 20 AX (200 µF) at AC 120/277 V, 15 AX (200 µF) at AC 347 V
- As built-in device with 1/2 inch thread connection for mounting to or in a UL/NEMA Junction Box with feedthrough of the function wires through the 1/2 inch threaded connector
Additional functionalities GAMMA
-
Selectable operating mode (normal mode, time switch mode)
-
Selectable relay mode (NO contact / NC contact)
-
Status object as an optional addition
-
Variable On and Off delay times
-
Selectable logic operation (AND/OR) of two communication objects
-
Selectable switching state at bus voltage failure and recovery
-
Optional addition of a night mode object for time-limited switching On of the output (and hence the illumination) at night
-
Variable On period at night or time switch mode
-
Selectable post-triggering of the On period (On period extension) in time switch mode
-
Selectable warning signal prior to imminent switching-off by means of three-times short off and on switching (flashing) at night or in time switch mode
-
Selectable function:
-
Including additional communication object for manual override of an output
-
Selectable forced control, including additional communication object for switching an output on or off in forced mode
-
Selectable counting of operating hours with threshold monitoring of the operating hours
-
Selectable counting of load cycles with threshold monitoring of the load cycles
-
Integrated 8-bit scene control and linking of each output into up to 8 scenes
HS Code: 85371091
Coo: Romania
