TS3 three-phase 3-ph 15 A 10 kW

Power thyristors

Application/type Power thyristors
Configuration DIP switches
Output voltage reference voltage for potentiometer: 10 V =
Output switch contact signal contact at 100% Ua, signal contact in case of fault state, changeover contact, 2A for 230 V ~, output for ohmic and inductive loads, 10 kW (400 V ~ / 15 A)
Input input for potentiometer 2,5..10 kΩ, PWM input 5 V / 5..10 kHz, input for PTC according to DIN 44081, input for reset, electrical activation via setpoint signal 0..10 V = or 0..20 mA, optionally configurable
Operating range temperature (°C) 0..+50
Operating ranges temperature (°C) 0..+50
Operating range humidity max. 95% rH non-condensing
Power supply L1, L2, L3, N: 400 V ~ 45..65 Hz, self-synchronizing
Power consumption typ. 40 W
Display 4 LEDs showing status of the device
Enclosure aluminium
Protection (IP) IP40, according to EN 60529
Connection terminal block
Mounting 4 mounting holes Ø=8 mm for mounting on galvanized mounting plates (control cabinet)
Device length (mm) 139
Device width (mm) 200
Device height (mm) 140
Catalogue table Power thyristors